Step 1:
Wind any tape you would normally use to conduct a
tape test, for example 600, 610, 810…,
through the equipment as shown. Any tape on a 3” core
that is between 1/4” and 1”
wide will work.
Step 2:
To begin a test, tip the equipment up-right, grab
the handle attached to the application brush and pull up
to dispense a length of fresh tape for each test.
Typical standards suggest approximately 3”, however,
we’ve found it beneficial to use 7" or more to see
patterns of adhesion.
Problems with Current Methods:
Tape on typical dispensers has area that is exposed
to drying or debris. When done by hand, oils from
fingers or other debris can get on the adhesive. Tape
easily tangles.
Step 3:
Place the equipment on the area of the substrate to
be tested. Return the brush to its home position. Note,
the brush counter-rotates across the tape with
consistent pressure and application motion, therefore
this operation can be repeated by any operator.
Problems with Current Methods:
Bubbles or missed areas occur. Different application
pressures, methods or patterns cause different bonds
between the tape and the stubstrate. This is very
difficult to
repeat by hand or from one operator to another.
Step 4:
Activate removal. When the tape removal is activated
a roller is lowered to ensure the tape is removed at 180
degrees from the angle of application. Again, a
repeatable action.
Problems with Current Methods:
It is nearly impossible for tape to be pulled at the
same angle and rate by each operator, each time, by
hand. Final results depend on how the operator performs
each test.
Step 5:
Review results. A viewing area is provided in the
front of the equipment. Use the same criteria you
normally use or reference the appropriate standard. You
have the option of removing the section of tape just
used for testing to keep with your records/retains.
Alternatively, you may record the date/job number on the
tape and store on the spool as a record of performing
the tests. You may also dispose of the tape neatly as
the spool becomes full.
Problems with Current Methods:
Tape curls, tangles and sticks to fingers. Wads of
tape end up strewn across work area. Tape must then be
attached to the sample or another record.
< previous page
